If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
Has anyone ran weld Drag lites, or Rod lites on there......
Has anyone ran weld Drag lites, or Rod lites on there......
Hey guys i was curious if anyone has ran rod lites or drag lites on there svo with tube a-arms and Late model cobra brakes. I have decide welds are what i am going with on the car and am having a hard time getting info on what wheel off set to get for the bid rotor up front. Thanks in advance for the help.
run prostars or rodlites, everyone runs draglites on there 5.O including me. take advantage on the 5lug
Jim
1986 Svo 1D-boost controller,bobs log,k&n,aeromotive afr,255pump,timing bumped up and boost to 17pounds
1991 mustang gt-mid 12's (stock heads and cam)oh yea
car looks badass, what mods do you have done to it? Also that thing sits low what springs are you using?
Jim
1986 Svo 1D-boost controller,bobs log,k&n,aeromotive afr,255pump,timing bumped up and boost to 17pounds
1991 mustang gt-mid 12's (stock heads and cam)oh yea
Let me first that thanks Jim ,As far as mods are concerned, the motor is a stroker, head is a big valve ported cast iron Turbo hear, with titanium valves and 7 degree locks, a234 cam which is coming out soon for a bigger better cam. Has tube K-member and control arms, coil over springs. The car is pretty much completely modded with exception of stock shocks and struts which will be replaced with lakewood 90/10's and 50/50's shortly. Has a T3/T4 turbo and nitrous. I am planning for low 12's or high 11's in the quarter
Jim
1986 Svo 1D-boost controller,bobs log,k&n,aeromotive afr,255pump,timing bumped up and boost to 17pounds
1991 mustang gt-mid 12's (stock heads and cam)oh yea
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment