If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I picked up a stainless elbow for my 3" outlet I'm building but the wall thickness is only .060". Is this thick enough for an elbow right off the wastgate or is it too light? Thanks in advance for the opinions, Bruce
It will be a little harder to weld but I see no problems using it. You will have to keep most of your heat on the cast and let the weld lay into the stainless.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment