HELP! hanging exhaust

[ryanc]

Im putting my stinger 3" exhaust (drivers side exit) with a borla 3" in/3" out offset/offset muffler on today and was wondering the best way to suport and hang it. Im guessing I will use the same hangers from the stock exhaust? any help would be great! thanks!

[NY eric]

Re use the stock hanger and you will need to fabricate on for the trans hanger.

[ryanc]

thanks. so do I just take the bracket that is on the stock muffler and weld that to the new muffler and put that in the stock hanger?

[8T6 SVO]

In my car when I got it, it had a exhaust out the drivers side with a Borla muffler. The rear seat was deleted and one of the seat belt bolt holes was re-used with a bolt & a hanger to support the muffler.

The pipe was also supported by the trans mount. This works well as you need to support the pipe in this location as well.

Whatever you do, your going to have to be creative.

HTH