Bi Wing Supports

[Bruce]

Just for the record I was looking in product reviews and saw the Bi Wing support comments. I made two for my car because the wing had broke! I tried to have it welded but my body man said he could not find out what it is made of. Bottom line is I took clear plexiglass and made pads for the glass then drilled two holes through into an other peice 90` on center, installing self tapping screws. Then I whitled away at the top till it fit the bottom of the wing! Being clear it looks good and supports the broken wing just fine! All I did to keep it there was silicon to the window and they have stayed just fine!

[jayG]

Bruce can you post a picture? thx..jayG

[SVOeric]

send it to me... I'll re-size it..

if you check the FAQ, there is a thread specifically about images, and resizing them. there is also a link to a program that will resize pictures very easily, and in that same post, it also tells you the pixel sizes you should use to keep things sane...

[SVOeric]

here is the pic --

ALSO --

I move this to the interior/body forum -- as it has good info in it, and the lounge area gets purged of old posts... the tech areas do not.

[Bruce]

The screw holes did not need to be that deep( would have looked better) but it was spring and I rushed a little! Still looks OK though. The camera made them highlighted, but in regular light they go almost unoticed.