Results 1 to 3 of 3

Thread: coolant lines

  
  1. #1
    6 PSI Boost
    Join Date
    Aug 2018
    Location
    Windsor Ontario
    Posts
    13
    SVO's: 1986 work in progres

    coolant lines

    Is there any ideas or locations where I cant get or make coolant lines to replace to hard lines.

  2. #2
    OVER-BOOST!! Kendal Coker's Avatar
    Join Date
    Jun 2002
    Location
    Decatur Alabama
    Posts
    1,063
    I talked to the place that made the ones for Forced 4 and they would not make less than 50 sets and I would have had to have a tax number (business) to buy from them. I did contact another place and had 10 sets made. They were so bad I took them to the scrap yard. Chad down here in Birmingham had someone make him a set in Florida but I cant remember who it was. I will see if I can get him to post who did them. They were quite expensive.
    Kendal Coker

  3. #3
    6 PSI Boost
    Join Date
    Aug 2018
    Location
    Windsor Ontario
    Posts
    13
    SVO's: 1986 work in progres
    may have come up with answer. The main problem it the heat generated on the turbo side. There is a reinforced silicone heater heater hose that is good up to 350 def F and also a thermo tec sleeve protector that slide over top that reflects 90 percent of the heat from the turbo and exhaust and is goof up to 2000 deg f. I am going to give it a try just have to come up with some T fittings for where intake and turbo coolant intersect

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •