Here is the latest dyno run from the 2005 Reunion dyno day for the Road Warrior.
193.2 RWHP
247.2 RWTQ
|
Here is the latest dyno run from the 2005 Reunion dyno day for the Road Warrior.
193.2 RWHP
247.2 RWTQ
Last edited by GAboySVO; 10-06-2005 at 05:19 PM.
Mike S
'86 SVO 9L Leather
'86 SVO 9L Road Warrior
'96 300ZXTT
Here is the picture
Mike S
'86 SVO 9L Leather
'86 SVO 9L Road Warrior
'96 300ZXTT
Here is my latest dyno sheet at 15psi with the following upgrades:
- 2.1 Boport Cam (advanced 12*)
- Evergreen turbo T04b compressor wheel and stage 3 turbine wheel in a 0.48 A/R housing
- Rod's header
- Boport ported Rapido head with 7.85:1 compression ratio
- 0.30 over pistons
- 3" SS downpipe w/o cat and 2.5" cat back system
- stock IC (for now)
Last edited by GAboySVO; 10-16-2009 at 11:55 AM.
Mike S
'86 SVO 9L Leather
'86 SVO 9L Road Warrior
'96 300ZXTT
mike, after my short lap around the block all I can say is she pulls real nice. Love that flat torque curve!!!!!
Me too!![]()
Mike S
'86 SVO 9L Leather
'86 SVO 9L Road Warrior
'96 300ZXTT
Sweet
Is that a 40+ hp gain just swapping to a pimp?
My base line stock HP was 193 RWHP. When I had the head work, Boport 2.1 cam and turbo upgrade, that gained 35 RWHP. The HP change from the stock PE to the Pimp was from 228 HP to 238 hp. When I was tuning the pimp, discovered I was having an issue with my Kirban AFPR and vacuum/boost leaks, so I had to replace it with a stock replacement and fix the leaks. I think the 10 additional HP is directly related to installing the pimp.
I have recently installed some new 60 lb/hr injectors and I'm currently tuning at my current boost level of 15 PSI. Based on the log file of my last dyno run, I was running out of injector at stock fuel pressure. This will allow me to reach my 300 HP goal once I get a FMIC installed.
If you notice the latest dyno torque graph compare to the previous one, you will notice that the curve is not as flat. This was due to the adjustable WG arm jam nut being loose which caused a reduction in the WG pre-load. I wasn't getting the full 15 PSI of boost until after ~5k rpm. It's fixed now and should show up in the next trip to the dyno.
Last edited by GAboySVO; 02-11-2016 at 05:58 PM.
Mike S
'86 SVO 9L Leather
'86 SVO 9L Road Warrior
'96 300ZXTT