If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I did a search & could not find much in this.. After I get my block back from the engine shop I was thinking about powder coating the block.. I can get a pretty good price on having it done.. Is there any reason that I would not want to do this?? I was thinking about doing the block & oil pan in gray..
I'm not sure you could powder coat it without causing paint to go where it shouldn't. I would also want to check with the powder coater on recomended heat applications.
As long as the coater uses the high temp tape and plugs and is mindfull of what they are doing, then you should be fine. Powder bakes at 350-400. A lot of places do engines. Mine is not powder coated, but I still run a 5.0 heavy duty 3-core radiater. If you have any questions call. Tony shop 570-879-0118 home 570-853-4697
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment