If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Decided to clean up the block and replace the headgasket and take a look at the bottom end. It's all back together and runs beautifully but the AMP light is still on!?! I have 14.7V at the battery so it's charging fine-I believe the upper limit of the voltage reg is 14.7. Any brilliant thoughts? All wires are connected. Which wire could break and cause this light to be on? Thanks in advance.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment