Connectin rod specs

[linuxman51]

What are (or where might I find) the specs for the rods? (length, big end size, how wide they are at the bottom, etc)

[KevinK]

from the 84 spec book

pin bore dia .9096- .9012
crank bearing bore dia 2.1720- 2.1728
out of round limit .0004
taper limit .0004
length center to center 5.2031- 5.2063
alignment bore to bore max diff.
twist .024
bend .012
side clearance to crank
std. .0035- .0105
service limit .014

[linuxman51]

Cool, what I meant by the width was the actuall width of the rod at the big end, not the service limits, sorry about the confusion. Thanks a lot for the rest!

[KevinK]

sorry

sorry that was not in the spec book.