Extended Stud Starter Solenoid?

[SVOMikey]

I've been doing some rewiring under the hood. I just added the 4AWG wire from my 3G Alt to the solenoid and I have a bunch of other junk that gets +12VDC from the hot post on the solenoid. I ran out of stud! I usually run a lock washer on there but there's not enough stud left for it.

Does anyone know of an application that uses an extended or longer stud on the solenoid? Maybe a truck or commercial vehicle? If not, I guess I need to run some type of distro block. Any recommendations on one of those?

Thanks! Mikey

[fastmonkeywheels]

Cavaliers came with a nice distribution block. I'm not sure what years.

[Pat_in_L.A.]

Try here:

http://www.delcity.net/delcity/servlet/catalog?category=New%20Catalog%20Products&page=1

[onthegosvo]

I purchased one from the following site. It has 7/8" long studs that are longer than the stock SVO starter solenoid switch:

http://www.ryderfleetproducts.com/cgi-bin/ryderfp/products/srm/oid/55290/pn/Solenoid-Switch/erm/product_detail.jsp

[SVOMikey]

Thanks Guys.

For now I'll try the longer post switch. If needed, I do like those distro blocks. I'll run an 8 awg wire over to one of those, but as space is tight, we'll try the switch 1st.

Mikey

[Pat_in_L.A.]

The switch that Steve posted looks like the better bet. I think it has the circuit protection in it as well. I'll have to order one up and check it out.