Tweet
I got 4 of these with my car and they are obviously for the interior trim somewhere but for the life of me I can't figure out where. Please help!
Attached Files
-
-
front seat rail cover
It covers the nut and seat mounting stud.
Held in place with one plastic push pin per cover
d423_1.JPG
The two at the top of the photo are for the front of the seat track.
The two at the bottom of the photo are for the rear of the seat trackLast edited by onthegosvo; 05-26-2009, 08:45 PM.Steve
1986 2A / 1984 1C -
I went out and checked on the car and I'm not seeing this being the seat rail cover. Looks like it but not the right size. I'll have to check again in the morning/daylight.
RickLast edited by 18lbs; 05-26-2009, 08:25 PM.Comment
-
Close. it goes on the back side of the rail where it bolts to the floor (passenger foot well). 2 per seatOriginally posted by onthegosvo View Post
Left above to show I dont know everything. (Ha! busted!)Confucius says" a closed mouth gathers no foot"Comment
-
he's correct..Comment
-
Thanks guys, got my answer in 16 minutes or less.Comment
-
I was correct in 4 minutesSteve
1986 2A / 1984 1CComment
-
Huh.....I used those as dampeners for my Flux Capacitor.....DannyComment
-
bearing covers for the hevershaft ??Growing OLD is mandatory,Growing UP is optionalComment
-
I thought that was the cover for the tail light fluid filler hole.Eric C
SVOCA WebmasterComment
-
Nope, more like the fluid drain hole. The filler hole has left-handed threads. You were close though.Originally posted by SVOeric View Post
On a more serious note.........Are these painted interior gray or black?Comment
-
-
I stand corrected, Steve did give me the info in 4 minutes. BTW my are black.Comment
Comment