When I went to install my new headlights (NOS) I notice the bottom "spring-thingy" at the end of the the handy dandy arm does not SNAP on to the screw-post like the top ones do. In fact, I can jiggle the light in and out about 1/8 inch. It isn't anywhere near as snug as the top ones. When I look at the headlight hole with the clip installed I notice very little of the "tab" sticking through the hole.
See pix. It is of the right light, and actually is better than the left (already on the car).
Any ideas on how to make that tab stick through more? Or should I just not worry about it?
See pix. It is of the right light, and actually is better than the left (already on the car).
Any ideas on how to make that tab stick through more? Or should I just not worry about it?
Comment