My engine dies when I come to a stop, when i start it up i have to keep it with a little gas to keep it going, once going it seems to be okay until the next stop, WHATS UP????
Announcement
Collapse
No announcement yet.
Engine Dies
Collapse
X
-
great.........I knew I had a vacuum leak some where.
although this has only happend to me once, I and I havent been able to find the leak.85.5 svo 1C
-Straight roads are for fast cars; curvy roads are for fast drivers.
-cars win races, drivers win championships.
http://www.cardomain.com/member_page...5&val=1&page=1
Comment
-
i took it and had it checked, i just talked to the guy they did a vacuum check so i am crossing out vacuum leak out, so must be IAC. would cleaning help or do i need anothre one. I have been reading and it seems IAC gives irregular idle. I die when i come to a stop, would it still be IAC.84
LA3 35#Inj Gillis valve
K&N cone w/ Bypass kit
3" downpipe w/ HF Cat.
Comment
-
You need to remove the IAC, take it apart, and clean the body inside and out with brake cleaner or similar. After you reinstall it, you should perform the base idle procedure as described in the FAQ section.Mike S
'86 SVO 9L Leather
'86 SVO 9L Road Warrior
'96 300ZXTT
Comment
-
CODES CODES CODES
these are the codes pulled up
22 barometric pressure sensor circuit
23 TPS circuit ( replaced TPS bout month ago)
26 airflow sensor circuit
54 airflow meter
81 thermactor diverter or bypass circuit
82 " " " "
83 low speed primary -fuel pump
What is all this in english to me, thank you , I know I know it seems to be a lot. I hope to fix this.84
LA3 35#Inj Gillis valve
K&N cone w/ Bypass kit
3" downpipe w/ HF Cat.
Comment
-
87 TC EEC is the computer i switched wires at the conecter.
I switched computer and car ran ok at first it didnt quite run hard in 3 or 4 and ran a lil hotter but seem to run better after i ran better gas. So do i need another EEC ??????84
LA3 35#Inj Gillis valve
K&N cone w/ Bypass kit
3" downpipe w/ HF Cat.
Comment
-
60 pic connector
i switched from reg to one of 87 TC
only mods are gillis vave and the computer and injectors, havent changed anything else
as for undoing sensors i am not that good a mech. i am used to older 5.0 and 5.8 this is my first venture to this type of engine84
LA3 35#Inj Gillis valve
K&N cone w/ Bypass kit
3" downpipe w/ HF Cat.
Comment
Comment