Tweet
the turn signal lights in the gauge cluster don't work but the turn lights work when i bought the car the lights would work intermitintly i've replaced the turn signal switch on the colum because it woulden't stay on left was hard to get into right (was a broken cast alumium guide) oh and i took a look at the lights in the cluster the filaments are intact any idea's on what it could be ?
-
86 2A Under reconstruction -
From the EVTM:
Check fuse #5 by operating the backup lights. (shares the same circuit)
Replace Turn Signal Flasher (round, barrel looking thingie in the fuse panel)
Check voltage of Turn Signal Flasher P/OH wire Between fuse 5 and flasher)
Check voltage at C211 LB wire (6 wire terminal to turn signal lever)
Replace turn signal lever (you already have)
Now, this is from the '85 EVTM, so I am thinking it is the same. If someone else can chime in with a difference, then cool. -
yes all the lights on the outside of the car work hazards turn signals but the lights in the guage cluster don't work for the turn signals or the hazards86 2A Under reconstructionComment
-
Look for a busted off ear on the socket that holds the bulb. It may not be making contact with the ribbon strip.Comment
-
i have to remove the guage cluster for that right how dose that speedo cable come off?86 2A Under reconstructionComment
-
Huh?Originally posted by jamman16 View Post
You got to them once already. Per your first post, "oh and i took a look at the lights in the cluster the filaments are intact any idea's on what it could be ?".
The bulbs mount (push in) to the socket, so per the above statement, you had the part out once already.
To remove the speedo cable, you pinch and twist the white housing of the cable end. No tools required.
No you don't have to remove the cluster.Comment
-
You got to them once already. Per your first post, "oh and i took a look at the lights in the cluster the filaments are intact
flashlight just looked at them as they are clear86 2A Under reconstructionComment
Comment